Handmade in the uk
Aston Martin DB2 Boot-Lid No. Plate Surround for Oblong Plates
New- DB2
- DB2/4
- DB2/4 MK2
Handmade from brass – rear number plate surround housings for standard, oblong type plates are fitted to the boot-lid of the DB2, DB2/4 and DB2/4 Mk2 models that house this number plate size.
Derived from drawings and measurements taken from original parts, and fabricated using our own DMark® custom tooling, jigs, patterns and aids – this surround housing type comes in three pieces; a long middle section and two short sides.
We’re not entirely sure why factory examples are made in three separate parts like this, but there we are! However, at DMark® we’re happy to accommodate those who would prefer to have it in one single piece, and/or specific to their particular number plate size if given the appropriate dimensions.
The factory version is 20 ⅜″ from inside edge across length (max width of number plate)
All DMark® DB2 rear number plate surround housings are finished as polished brass, ready for chrome.
Customers have the option to receive their new body-lid number plate surrounds in polished brass or chrome.
Be rest assured at DMark® we only work with long-standing, reputable electroplating firms for our work and products. These DB2 ear number plate surround housings are essentially a “bolt-on” component so some clients prefer DMark® to handle the chrome plating. However we do appreciate there are others who will handle the chrome plating themselves and prefer to have their component in polished brass. Perhaps you’re restoring the whole car and want to have all your chrome plating done at once after a dry-fit?
For the most part, these housings are Made-to-Order.
Fixtures and fasteners (nuts and bolts) are supplied.
Customers will be aware that, in particular, when vehicles have had extensive repairs; their bodywork, paintwork and the extent of body-filler used can change the panel-shape of the zone mouldings are meant to sit. At DMark® we have taken great care to replicate the most original shape known but occasionally that may differ from the surface geometry of a vehicle. A similar scenario could also mean stud holes in the bodywork may differ to the stud and fixing positions of new DMark® parts.
Rear number plate housing for a standard, oblong type number plates that fit the vehicle’s bootlid. This version is a single component rather than three separate pieces.
Rear number plate housing for a standard, oblong type number plates that fit the vehicle’s bootlid. This version is in three parts and appears to be as-per factory examples.
Rear number plate housing for a standard, oblong type number plates that fit the vehicle’s bootlid. This version can be a any custom width and be in either one or three parts.
Ideally we would like as many dimensions as possible, a good starting point would be measurements for;
- dimensions of the actual number plate
- location of any fixture holes on the plate
Customisation
This variant can be made specifically to your dimensions. Bespoke to you.
Talk to us first then send measurements, diagrams or a hand drawn sketch, annotated photos or CAD, even faded old drawings.
Bespoke by DMark®
